Hi-pot Type Testing Application Note
This Application Note was written to provide insight into the one time requirement for ‘type' testing of power supplies by the safety agency or manufacturer. It will assist in the interpretation of requirements for this testing and provide broad guidelines on exactly what is required of the manufacturer in this test procedure.
This application note is written primarily with regards to Class I power supplies that have a safety earth ground. At the end of the document there is a section that outlines the differences for Class II power supplies.
Download to find out more.
Read More
By submitting this form you agree to XP Power contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. XP Power web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Capacitors, Components, Power, Transformers
More resources from XP Power
Eliminating snubber circuits in AC/DC power supplies through the use of silicon carbide diodes
Silicon carbide diodes have been around for some time now but have had little take-up in power supplies due to their relatively high cost. XP Power...
Digital Signals and Controls
Digital signals and controls are in increasing demand in building management, telecommunications and networking applications. One of the main requi...
Input Considerations
It is important to confirm the AC voltage, frequency, and phase when selecting a power supply as these differ from region to region. If more than t...
